Commercial Gates in Georgetown, TX

Request a bid with your site plan, gate count and vehicle mix, and our estimator will walk the property and price the entry from what the walk shows.

Commercial Project Size and Scope

A commercial gate project is sized by the opening, the traffic that passes through it and the hours the property runs, not by the look of the leaf.

An ornamental walk-through gate beside a cantilever gate clearing a wide or sloped entry lets staff and visitors enter on foot while the vehicle leaf stays closed. A recurring gate service plan suits a property with six commercial gates, because gates of different types wear at different rates. We specify galvanized steel for posts and powder-coated steel for the visible leaf, while hand-forged wrought iron and a welded ornamental fence suit an office frontage. An industrial yard cycles its gate all day with heavy vehicles, while a storage facility cares most about keypad logs and after-hours control.

A commercial gate bid is an estimate built from the opening width, the number of vehicle lanes and whether power already reaches the post. The table lists the systems we bid most, each priced as an estimated range for a complete system.

Payment typically runs a 50% deposit, a 25 to 40% progress draw and the final 10 to 25% on commissioning. These figures are budgetary estimates, subject to change, and the written quote we issue after reading your plans and walking the site sets the final price and the schedule.

Harriet's job in Round Rock began with a shared truck entrance on a fire lane, where the gate needed the fire department's switch and sensor, so the entry could not open until the fire marshal's hardware was in. We built a 26 ft cantilever across a loading entrance in galvanized steel, powder coat, with a Knox key switch, an Opticom receiver, photo eyes and edge sensors. The job sat near Old Settlers Park at an estimated $7,400 to $9,800 over an estimated 3 to 4 days, and the gate passed the fire marshal's test, so deliveries now run through it.

Working Around Occupied Properties

We keep an occupied property open by splitting the work into phases that never close the only entrance. The leaf is hung in a single shift at night or on a weekend. Crews of 3 to 4 handle the motorized work, and the same phased sequence runs on jobs in Steiner Ranch, Lost Creek and Volente.

Commercial Service Areas

We install commercial gates inside a 45-mile radius of Georgetown, from Leander and Cedar Park to Round Rock. Properties in Serenada and Volente often sit behind shared easements, so we confirm access before fabrication. Rollingwood and West Lake Hills lots tend to be steep, which favors a cantilever gate clearing a wide or sloped entry over a ground track. Steiner Ranch and Lost Creek storage pads usually want keypad logs on the entry.

In Sunset Valley, Winston called about a property with six gates, three of them stuck open for months, off Brodie Lane. Xavier, on Jones Road, had a yard with a thin chain link perimeter that was cut twice, and we replaced it with a 200 ft perimeter run of anti-climb steel panels. We have also worked near the Old Town overlay in Round Rock and in the Leander station area, so we ask about frontage review early. Our home page, Georgetown Metal Gates, lists every city we serve.

Request a Bid

Send the site address, the opening width and the vehicle types that use the entry, and request a bid for your commercial gate. We will schedule the walk, check the fire-lane requirements and return a written scope and price range.